How to install and maintain mine dryer

波多野结衣在线

Product search:

How to install and maintain mine dryer

Mine dryer is also known as rotary dryer, drying materials are slag, limestone, coal powder, clay and so on. At present, it is widely used in building materials, metallurgy, chemical industry, cement and other fields.

Because the market of mine dryer is very good, so the comprehensive utilization rate in the market is also very high, which is favored by the majority of users. However, many users do not have a thorough understanding of the installation and maintenance of the equipment. In order to better understand the equipment, this paper introduces how to install and maintain the mine dryer.

 Mine dryer

Installation of mine dryer

1. Before installation, check whether the parts are complete according to the list;

2. In order to avoid shaking during operation, the equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts;

3. Pay attention to whether it is installed vertically with the host;

4. After installation, check whether the bolts of each part are loose, and check whether the door of the main engine room is fastened. If there is any problem, fasten it in time;

5. The power line and control switch of the equipment should be configured according to the power size of the equipment, so as to avoid the phenomenon of power failure;

6. After the completion of the test, to carry out no-load test, if the test run is normal, then the equipment can start to work.

 Installation of mine dryer

Maintenance of mine dryer

Regular maintenance can not only prolong the service life of the equipment, but also improve the drying efficiency of the equipment. The maintenance of the equipment is introduced below.

1. Bearing plays a very important role in the equipment, so in the daily work, we must do a good job in the lubrication of the bearing, add appropriate lubricant to ensure that there is no impurity in the lubricant, and the sealing is good;

2. When working, it is necessary to observe whether there is bolt loosening or wearing of vulnerable parts. If there is looseness, it must be tightened and replaced in time;

3. If there is abnormal vibration or noise during operation, it may be that the equipment is out of order. At this time, it is necessary to stop the machine in time and start the equipment operation after the fault is eliminated;

4. After starting the work, it is necessary to ensure that the feed inlet is evenly fed, neither too much nor too little, so as to ensure the drying efficiency of the equipment and prolong its service life.

 Maintenance of mine dryer

After purchasing the equipment, users should regularly maintain and maintain the equipment according to the correct maintenance method, so as to prolong the service life of the equipment and create higher profits for users.

Copyright (c) 2015-2016 address: No.8 Tanxiang Road, high tech Zone, Zhengzhou City, Henan Province