Industrial dryer Henan Hongxing

波多野结衣在线

Product search:

Industrial drying machine

Industrial dryer is usually used in mineral processing, metallurgy, construction, road construction and other industries, there are many types of industrial dryer, most of them include Slag dryer Three cylinder dryer Sand Dryer All kinds of equipment such as dryer.

 dryer

Scope of application

Industrial dryer is mainly used in mineral processing, building materials, metallurgy, chemical industry and other departments to dry materials with certain humidity or particle size.

working principle

The industrial dryer is based on the suction of the exhaust fan. After heating the air through the heat exchanger, the rotating inner cylinder constantly turns over the dried fabric for heat exchange, so that the moisture contained in the fabric is heated and vaporized, and the clothes can be dried in a short time.

Performance characteristics

1. The multi combined lifting device has high thermal efficiency and low coal consumption.  

2. It is suitable for a variety of combustion furnaces, such as high temperature fluidized bed furnace, coal pulverizing and powder injection furnace and manual coal feeding furnace.

3. The pin column replaceable gear is used in the transmission of large and small gears, which replaces the traditional cast steel gear, saving the cost and investment, and greatly reducing the maintenance cost and time.  

4. The centralized control system can be used to monitor and manage large enterprises.

Operation steps of industrial dryer

1. Open the door, evenly rotate the dehydrated material in the drum, and then close and lock the door.

2. According to the fabric type, select the appropriate time and adjust the timing device to the required time.

3. Press the start button to start the fan. According to the user's needs, the rotation direction of the drum can be selected as one-way rotation or two-way rotation. As long as the computer board switch is turned to one-way or two-way, the machine will perform one-way or two-way operation according to the requirements. (forward rotation 25 seconds, stop 5 seconds, reverse 25)

4. Often watch the internal fabric overturning from the observation window. In case of any accident, the power supply should be cut off in time.

5. When the machine runs to the specified time, the machine will stop automatically. At this time, the operator must open the door to dry the inner fabric. If not, the time can be extended appropriately.

Copyright (c) 2015-2016 address: No.8 Tanxiang Road, high tech Zone, Zhengzhou City, Henan Province